Widely used Hammelite Hammer Finish paint is based on high quality alkyd resin .It is highly bright, smooth, and it is highly resistance to rust and adverse weather. Hammelite Hammer Finish is used on metallic object, especially usable for steel Almirah and any other steel furniture.
Preparation for the site: Before applying paint, dust, oil and grease should be cleaned up properly from specific place. Any kind of unequal or bending portion should be equaled. Use 120 sand paper or Emery paper to remove old paint, dust, oil.
Step-1: The application of sealer is dependable completely on surface. Victory U Anti Corrosive Red Oxide is used as primer. Then give 18 - 24 hours for dried up.
Step-2: At first, Apply 1 coat paint lightly after thinning Hammelite Hammer Finish paint as per requirement. After 10 minutes, thin paint as per requirement and then apply it on required place as top coat. For small grain, thin it little more, and for big grain, thin it little less. Use our X brand or Hammer Brand copal varnish for getting good pattern. Do not spray over that should be kept it mind because excess falling paint can break down the pattern. Per litre coverage is about 120 sft - 130 sft.
Special Note: The pressure of air should be kept 50-60 pounds per sft. The difference between Spray machine and surface is kept 9”(inch). Clean spray and other instruments with thinner immediately after uses. It is better that stir the mixed paint at stretch or continually to get the same pattern.